Electia SDA-9 Betriebsanweisung PDF herunterladen (Seite 23)

821667: VAMP2 Series User Guide

VAMP2 Series User Guide

Rear Panel Connectors

Figure 1–7 AUX 2 - AES Input Termination

• AUX 1 & 2 Input 1 & 2 (on BNC): The four BNC connectors in the

AUX 1 and AUX 2 input sections accept standard AES audio signals

and are configured for unbalanced connections (75  impedance).

See the Audio Source Select button and the Audio Analog/AES

Select button for instructions for selecting these inputs for

monitoring.

• External Speakers (Speaker Binding Posts, Left and Right): Connect

external speakers to these binding post terminals. The left pair

outputs the signals as selected for the left speaker and the right pair

outputs the signals as selected for the right speaker. The binding

post terminals in each output pair are color-coded for polarity; red

is positive (left terminal) and black is negative (right terminal). An

external amplifier is not needed to drive the external speakers.

• VAMP2 Analog In & Metered Analog Out (DB-25-F): This

connector accepts balanced, low impedance, line level analog

signals. See Figure 1–8 below for pin-out information. This

connector has the same pin-out as the Tascam analog DB-25.

Figure 1–8 Analog In and Metered Analog Out

Connector Pin-Out

1234

Up: Unterminated

Down: Terminated

AUX 2, AES 1 Balanced

AUX 2, AES 1 Unbalanced

AUX 2, AES 2 Balanced

AUX 2, AES 2 Unbalanced

1 2 ... 18 19 20 21 22 23 24 25 26

Keine Kommentare

Electia SDA-9 Betriebsanweisung Seite 23