Electia SDA-9 Betriebsanleitung PDF herunterladen (Seite 10)

GUIDE TO INSTALLATION AND OPERATION

6 | SDA-1401

The local control panel is fastened to the controller

card by a hinged connector, and when installed is

located in the front center of the frame, positioned in

front of the power supplies. The panel consists of a

display unit capable of displaying two lines of text,

each 16 characters in length, and five pushbuttons.

The panel is assigned to operate any card in the

frame by pushing the SELECT button on the front

edge of that card.

• Pushing the CONTROLLER button on the

control panel selects the Controller card

itself.

• The STATUS LED on the selected card

flashes yellow.

The local control panel displays a menu that can be navigated using the four pushbuttons located beneath

the display. The functionality of the pushbuttons is as follows:

[+] [–] Used for menu navigation and value modification

[SELECT] Gives access to the next menu level. When a parameter value is shown, pushing this button

once enables modification of the value using the [+] and [–] buttons; a second push confirms the

new value

[ESC] Cancels the effect of parameter value changes that have not been confirmed. Pushing [ESC]

causes the parameter to revert to its former value.

Pushing [ESC] moves the user back up to the previous menu level. At the main menu, [ESC]

does not exit the menu system. To exit, re-push the [SELECT] button for the card being

controlled.

If no controls are operated for 30 seconds, the controller reverts to its normal standby status, and the

selected card’s STATUS LED reverts to its normal operating mode.

3.3.2 Menu for local control

The SDA-1401 has operating parameters which may be adjusted locally at the controller card interface.

• Press the SELECT button on the SDA-1401 front card edge to assign the Densité frame’s local

control panel to the SDA-1401

• Use the keys on the local control panel to step through the displayed menu to configure and adjust

the SDA-1401

The complete menu structure is shown in the Annex to this document, beginning on page 14.

SELECT

ESC

CONTROLLER

Figure 3.1 Densité Frame local control panel

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16 17 18

Keine Kommentare

Electia SDA-9 Betriebsanleitung Seite 10